Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Clogging in pipe and nozzle

Posted Jan 19, 2015, 2:39 a.m. EST Fluid & Heat, Computational Fluid Dynamics (CFD), Microfluidics, Mesh Version 4.4 0 Replies

Oak Yannapol
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear All,

I am a novice user. I would like to simulate clogging in pipe and nozzle.
The cause of clogging is solid particle inside the fluid which deposits along the pipe and the nozzle tip.

Do you think which modules I should select ?
(Should it be Microfluidic (two-phase flow), or FSI or any others module )
Are there any models related to my problem ?

Please advice...

Best Regards,
OAK YANNAPOL
0 Replies Last Post Jan 19, 2015, 2:39 a.m. EST
COMSOL Moderator

Hello Oak Yannapol

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content