Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Recalculating solution only for point probe

Posted Aug 30, 2013, 11:40 a.m. EDT Heat Transfer & Phase Change, Results & Visualization, Studies & Solvers Version 4.3 0 Replies

Bart Van de Wal
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I am using comsol to model heat transfer in solids, but I am mostly intrested in the solution at certain points. I know that I can use domain point probes for this purpose, but I was wondering whether it is possible to 'switch off' all other calculations (like the isothermal contours that are provided and the temperature distribution over the whole domain).
More specifically: when I construct my geometry, and I make small changes (location of point probe, material properties, etc.), I want to recalculate the solution only at this one point, without all the other stuff. This would be a major time saver if this would be possible.

Thanks in advance
0 Replies Last Post Aug 30, 2013, 11:40 a.m. EDT
COMSOL Moderator

Hello Bart Van de Wal

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content