Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Ignore failed simulations in sweep

Posted Sep 17, 2022, 5:53 a.m. EDT Cluster & Cloud Computing, Studies & Solvers Version 6.0 1 Reply

David Muramatsu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi there,

is it possible to ignore the failure of single simulated parameter sets within a parameter sweep (Batch Sweep or Parametric Sweep)? I know that for some parameter sets I will run into vrey steep gradients but am not sure for which. I would like to simulate all parameter sets if possible and not have the sweep terminate if one parameter set fails.

Best and thank you in advance for ideas,

David

1 Reply Last Post Oct 15, 2022, 3:51 a.m. EDT
David Muramatsu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 2 years ago Oct 15, 2022, 3:51 a.m. EDT

After some more searching, I found a reply to a similar question here: https://www.comsol.de/forum/thread/117171/how-to-continue-a-parametric-sweep-in-case-of-a-problem

After some more searching, I found a reply to a similar question here: https://www.comsol.de/forum/thread/117171/how-to-continue-a-parametric-sweep-in-case-of-a-problem

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content